It is presented an alternative procedure for preparation of biodiesel samples for elemental determination by inductively coupled plasma optical emission spectrometry (ICP OES), based on the sample (10% m/v) emulsion formation with formic acid (15% v/v) and Triton X-100 (0.1% m/v). These concentrations were optimized and the stability of emulsified aqueous standards and samples was found to be of at least 3 h. Experimental conditions (1500 W of RF power and 0.5 L min-1 of Ar nebulizer flow rate) were optimized from those recommended by the equipment manufacturer, with a solution containing 10 mg L-1 of each analyte prepared with mineral oil in the same conditions of the emulsion. Matrix effects were investigated by observing the slopes of analyte addition curves for different biodiesel samples. Results showed that external calibration with inorganic aqueous standard solutions in the emulsion medium should be used. Limits of detection obtained (in mg kg-1) were 0.121, 0.008, 0.006, 0.001, 0.006, 0.071, 0.241 and 0.024 for Ca, Cu, Fe, Mn, Mg, Na, K and Si, respectively. The accuracy of the procedure for Ca, Mg, K and Na was assessed by the analysis of a multi-element standards B100 biodiesel (Conostan) and the recoveries ranged from 91 to 107%. The proposed procedure used low toxicity reagents and showed to be a simple and straightforward alternative of sample preparation for metal determination in biodiesel by ICP OES with limits of detection adequate for those analyses.
biodiesel; emulsion; formic acid; ICP OES
